AAton XTRprod User's Guide download pdf (Page 26)

2.2.9 Adjusting the Viewing Screen

The image on the viewing screen should be sharp, and its focus

should match to that of the ﬁlm. This can be best determined with

the use of a collimator, or by looking through the viewﬁnder and

checking that the sharp focus of a lens matches the measured

distance on its barrel. If it does not, then you need to make an

adjustment of the viewing screen focus.

To proceed, you must ﬁrst unscrew and remove the circular cap

located on behind the camera boy Run/Test switch.Inside the access

hole, inser a 2mm Allen wrench and screw or unscrew it. Replace

the circular cap. Use a collimator to check that you have reached the

sharpest focus of the viewing screen image. If the image is not yet

sharp ennough, proceed again.

2.10 Aatonite Illumination

The XTRprod features illuminated viewing screen markings referred

to as Aatonite. The level of illumination is adjustable by the user via

the Jog wheel, which is located to the right of the motor. To operate

Aatonite, power the body and switch the run/test switch to test

position and off again to turn on the camera electronics. Look

Attention !

Each time you're touching the

mirror, the viewing screen, or

anything inside the lens port,

disconnect the battery. You

will therefore avoid any risk of

seriously damaging your

camera.

USER 16 US.sept 6/12/97 17:28 Page 26

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 55 56

No comments

AAton XTRprod User's Guide Page 26