AAton XTRprod User's Guide download pdf (Page 50)

• 3 - Check that the exposed lens of the CCD head assembly is free

of dust particles. If necessary, clean this surface with lens ﬂuid

applied with a foam or cotton Q-tip. In order to install the head

assembly into the side cavity, ﬁrst feed the Lemo14 connector into

the PBX so that it faces towards the rear of the camera. With the iris

rod facing up, install the head assembly into the tubular holder until

the steel collar is stopped by the tube.

• 4 - While holding the head assembly in place, locate the allen set

screw in the diagram above and tighten moderately until the head

assembly is secure. To avoid any damage to the relay lens housing,

do not overtighten this screw.

• 5 - Position the Lemo14 in its cutout within the PBX and hold in

place. Make sure that the ﬂat index towards the rear of the

connector faces up and mates with the ﬂat in the cutout. Do not

confuse this ﬂat with the two ﬂats on the threaded portion of the

Lemo.

• 6 - Replace the rubber gasket and the PBX cover plate via the four

allen screws. Double-check that the Lemo14 sits ﬂush against the lip

of the circular opening in the cover plate.

USER 16 US.sept 6/12/97 17:29 Page 50

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 56

No comments

AAton XTRprod User's Guide Page 50