AAton XTRprod User's Guide Page 22

  • Download
  • Add to my manuals
  • Print
  • Page
    / 56
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 21
the hyperlong finder, which is twice as long as the standard
extension finder, can be used.
Note that standard short eyepiece can now be equipped with a
heating system; in order to avoid any condensation on the eyepiece
lens. Aaton can provide you a heating lens and the corresponding
Amph9 cable.
2.2.2 Attaching the Extension Finder
In order to use an extension finder on the XTRprod, the standard
eyepiece must first be removed. To remove the eyepiece, locate the
eyepiece lock ring, marked A in the photo below. Rotate counter-
clockwise and gently pull off the eyepiece. To install the extension
finder, locate the protruding guide pin on the seat of the viewfinder
and align the pin with the hole in the flange of the finder. Mate the
flange to the seat of the viewfinder and tighten the lock ring until it
is set firmly in place. During this procedure, you will notice that the
extension finder needs to face 180° away from the operators eye to
be installed onto the viewfinder. Because of its optical construction,
this is completely normal. After installation, rotate the finder 180°
to regular viewing position.
2.2.3 Viewfinder Tension Adjustments
The large knurled knob at the base of the left/right lateral
movement point (b) locks the lateral positioning.
The friction adjusting ring, located behind the eyepiece lock ring,
can be used to adjust the tension of the eyepiece swivel, depending
on the operator’s preference and the viewfinder being used. When
using the standard eyepiece, tension should be relatively light to
allow for movement with a moderate amount of pressure. When
using the standard extension finder, tension should be increased to
hold the additional weight of this finder in place.
To adjust the tension of the swivel, loosen the steel knurled screw (c)
located on the friction adjusting ring. Hold the eyepiece in place,
22
USER 16 US.sept 6/12/97 17:28 Page 22
Page view 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 55 56

Comments to this Manuals

No comments